Secondary Air Injection Pump Motor -V101-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Locating Front/Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When installing, bring all cable ties back to same positions.

-- Remove the front noise insulation -1-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Disconnect the connectors -3- and free them up.

-- Press the release buttons and remove the secondary air hoses -1-.

NOTE:

Ignore items -2 and 5-.

-- Remove the nuts -4- and the Secondary Air Injection Pump Motor -V101-.

Fig 2: Component Location Of AIR Pump Motor -V101-

Courtesy of AUDI OF AMERICA, LLC