Overview - Secondary Air Injection System
WARNING: This page is about a different variant/trim than selected.
- Secondary Air Injection Pump Motor -V101-
- Installed location: in the front of the engine compartment on the right side under the longitudinal member
- Removing and installing. Refer to Secondary Air Injection Pump Motor -V101-, REMOVING AND INSTALLING
- Checking in Guided Functions see Vehicle Diagnostic Tester
- Bracket
- For Secondary Air Injection Pump Motor -V101-
- Nut
- Tightening specification: 9 Nm
- Nut
- Tightening specification: 9 Nm
- Nut
- Tightening specification: 9 Nm
- Hose
- From air filter housing
- O-Ring
- Replace
- Hose
- To Secondary Air Injection (AIR) combi-valves
- O-Ring
- Replace
- O-Ring
- Replace
- O-Ring
- Replace
- Bonded Rubber Bushing
- Quantity: 3
- Hose
- From Secondary Air Injection Pump Motor -V101-
- Seal
- Replace
- Bolts
- Tightening specification: 9 Nm
- Vacuum Hose
- Right Secondary Air Injection Combination Valve
- Check the functionality and for leaks. Refer to SECONDARY AIR INJECTION COMBINATION VALVES, CHECKING FOR FUNCTION AND LEAKS
- Removing and installing. Refer to SECONDARY AIR INJECTION RIGHT COMBINATION VALVE, REMOVING AND INSTALLING .
- Bolt
- Tightening specification: 9 Nm
- O-Ring
- Replace
- Secondary Air Injection Sensor 1 -G609-
- Removing and installing. Refer to Secondary Air Injection Sensor 1 -G609-, REMOVING AND INSTALLING
- Bolt
- Tightening specification: 9 Nm
- Left Secondary Air Injection Combination Valve
- Check the functionality and for leaks. Refer to SECONDARY AIR INJECTION COMBINATION VALVES, CHECKING FOR FUNCTION AND LEAKS
- Removing and installing. Refer to SECONDARY AIR INJECTION LEFT COMBINATION VALVE, REMOVING AND INSTALLING
- Vacuum Hose
- Bolts
- Tightening specification: 9 Nm
- Seal
- Replace
-- Tighten the heat shield bolts -arrows- -1- to 9 Nm.
-- Tighten the heat shield bolts -arrows- -1- to 9 Nm.