LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (3.0L - Exhaust System & Emission Controls - Engine Code(S): CJTB, CJTC, CNAA, CJWB, CJWC, CJWE, CTWA, CTWB) >> 26 Exhaust System, Emission Controls >> Muffler >> Front Muffler, Removing And Installing >> Removing

Front Muffler, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.
Fig 1: Locating Front/Rear Noise Insulation
GWWA10-10441Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear noise insulation -2-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove the bolt -2- and the nuts -3-.

-- Loosen the nuts -1-, slide the clamping sleeve toward the rear and remove the front muffler.

Fig 2: Identifying Front Muffler Nuts & Bolts
GWWA26-10965Courtesy of AUDI OF AMERICA, LLC