Engine, Securing On Engine And Transmission Holder
Special tools and workshop equipment required
- Engine Sling 2024 A
- Engine And Transmission Holder VAS6095 with Engine/Transmission Holder - Universal Mounting VAS6095/1 and Engine/Transmission Holder - V6 FSI Bracket VAS6095/1-5
- Shop Crane VAS 6100
- Lift Arm Extension VAS6101
Procedure
- Engine/transmission assembly removed and separated on Scissor Lift Table VAS6131B. Refer to ENGINE AND TRANSMISSION, SEPARATING .
- Engine secured with Joint Support VAS6131/13-7.
-- Remove the bolts -arrows- from the left engine mount.
Ignore item -1-.
Risk of accident!
- The engine may be transported only in the manner described and without the transmission.
- The engine is separated from the transmission. Refer to ENGINE AND TRANSMISSION, SEPARATING .
-- Engage the Engine Sling 2024 A on the engine lifting eyes and on the Shop Crane VAS6100 with Lift Arm Extension VAS6101 as shown in the illustration.
To be aligned to the center of gravity of the engine assembly, the hole rails of the lifting hook must be inserted as shown in the illustration.
There is the risk of an accident.
- Lifting hooks and alignment pins on the engine sling must be secured with locating pins -arrows-.
-- Remove the Joint Support VAS6131/13-7 from the engine -arrow-.
-- Raise engine from engine carrier.
-- Remove the bolts -arrows- and remove the right -1- and left engine supports.
-- Secure the engine with Engine/Transmission Holder - Universal Mounting VAS6095/1 and Engine/Transmission Holder - V6 FSI Bracket VAS6095/1-5 on the Engine And Transmission Holder VAS6095 to 40 Nm as shown in the illustration.