Fuel Pump Control Module -J538- (VEHICLES THROUGH OCTOBER 2006): Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Fuel Pump (FP) Control Module, Bolts -1 & 3-, And Electrical Connector -2-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The Fuel Pump Control Module -J538- is located at the front of fuel tank below exhaust system and driveshaft.

-- Turn the ignition and remove the ignition key.

WARNING:

Danger of getting burned.

-- Remove the bolts -1 and 3-.

-- Disengage the Fuel Pump Control Module -J538- at bracket -arrows-.

-- Disconnect electrical connector -2-.