LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Fuel Supply System - Engine Code(S): Bar, BHK, BHL, CJWB, CJWC, CJWE, CTWA, CTWB) >> 20 Fuel Supply >> Removal And Installation >> Fuel Pump Control Module -J538- (VEHICLES FROM NOVEMBER 2006) >> Removing

Fuel Pump Control Module -J538- (VEHICLES FROM NOVEMBER 2006): Removing

WARNING: This page is about a different variant/trim than selected.
NOTE:

The Fuel Pump Control Module -J538- is located on the right side under the rear seat bench, directly under the floor covering.

-- Turn the ignition and remove the ignition key.

-- Remove right seat frame in 2nd row. Refer to SECOND ROW, 2 PASSENGER OVERVIEW .

-- Remove sill trim strip. Refer to SILL PANEL STRIP, REMOVING AND INSTALLING .

-- Press the floor covering to the side and disconnect the connector -1-.

Fig 1: Fuel Pump (FP) Control Module -J538- And Fasteners (For Vehicles From 11.2006)
GWWA20-10326Courtesy of AUDI OF AMERICA, LLC

-- Remove nuts -arrows- and remove the Fuel Pump Control Module -J538-.