LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (3.0L - Cooling System - Engine Code(S): CJTB, CJTC, CNAA, CJWB, CJWC, CJWE, CTWA, CTWB) >> 19 Cooling System >> COOLANT PIPE AND After-Run Coolant Pump -V51- >> Left Rear Coolant Pipes On Transmission, Removing And Installing >> Removing

Left Rear Coolant Pipes On Transmission, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Left Rear Coolant Pipes On Transmission Clamps And Bolts
GWWA19-11087Courtesy of AUDI OF AMERICA, LLC

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the left catalytic converter. Refer to LEFT CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Free up the B+ wire -2- and the transmission vent hose -4-.

-- Remove the bolts -arrows-.

-- Loosen the clamps and remove the coolant hoses -1 and 3-.

-- Remove the left rear coolant pipes.