LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (3.0L - Cooling System - Engine Code(S): CJTB, CJTC, CNAA, CJWB, CJWC, CJWE, CTWA, CTWB) >> 19 Cooling System >> COOLANT PIPE AND After-Run Coolant Pump -V51- >> Left Coolant Pipes, Removing And Installing >> Removing

Left Coolant Pipes, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Vehicles without After-Run Coolant Pump -V51- :

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

Vehicles with After-Run Coolant Pump -V51- :

-- Remove the after-run coolant pump -V51-. Refer to After-Run Coolant Pump -V51-, REMOVING AND INSTALLING .

All Vehicles

Fig 1: Connector For Wiring To Air Conditioning Compressor Clutch Solenoid & Compressor Mounting Bolts
GWWA10-10118Courtesy of AUDI OF AMERICA, LLC

-- Remove Air Conditioning (A/C) compressor. Refer to MECHANICALLY DRIVEN A/C COMPRESSOR: .

-- Remove the bolts -arrows- and the A/C compressor bracket.

Fig 2: Air Conditioning Compressor Bracket Bolts
GWWA10-10150Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

Fig 3: Bolts And Coolant Pipe From Engine
GWWA19-10022Courtesy of AUDI OF AMERICA, LLC

-- Loosen the clamps -1 and 2- and remove the coolant hoses from the coolant pipes.

NOTE:

The installation location is shown with the power steering pump removed.