Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

-- Open the cap on the coolant reservoir to release any pressure in the coolant system and then close it again.

-- Remove the front engine cover -1- upward.

Fig 1: Engine Cover

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -arrow-.

-- Disconnect the connector -1-.

NOTE:

Use a cloth to catch any leaking coolant.

-- Remove the retaining clip -2- and the Engine Coolant Temperature Sensor -G62-.

Fig 2: Engine Coolant Temperature (ECT) Sensor -G62- location

Courtesy of AUDI OF AMERICA, LLC