LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (3.0L - Cooling System - Engine Code(S): CJTB, CJTC, CNAA, CJWB, CJWC, CJWE, CTWA, CTWB) >> 19 Cooling System >> COOLANT PIPE AND After-Run Coolant Pump -V51- >> Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING >> Installing

Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-ring.

To prevent loosing coolant, install the new Engine Coolant Temperature Sensor -G62- right away into the front coolant pipe.

-- Check the coolant level. Refer to COOLANT, DRAINING AND FILLING .

scientia non olet · About LEMON Manuals