Pistons, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

NOTE:

Replace any bolts that were tightened with an additional turn.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston and piston ring compressor.

Installed position:

-- Install the connecting rod bearing cap according to the marking.

-- Install the oil pan upper section. Refer to UPPER OIL PAN SECTION, REMOVING AND INSTALLING .

-- Install the cylinder head. Refer to CYLINDER HEADS, REMOVING AND INSTALLING .