Left Cylinder Head Cover, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
- Tightening specifications. Refer to Figure.
NOTE:
Replace the O-ring.
Replace the cylinder head seal if it is damaged.
Replace the cylinder head cover bolts when replacing the damaged seal.
-- Clean the sealing surfaces; they must be free of oil and grease.
-- Tighten the left cylinder head cover bolts. Refer to Figure.
-- Install the ignition coil. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .