Overview - Power Take-Off Drive Chain
WARNING: This page is about a different variant/trim than selected.
- Crankshaft
- Drive chain
- For power take-off
- Mark the running direction with paint for reinstallation
- Removing and installing. Refer to POWER TAKE-OFF DRIVE CHAIN, REMOVING AND INSTALLING
- Drive Chain Sprocket
- For the oil pump
- Installed position: the side with lettering on it faces the engine
- Bolt
- 30 Nm + 90° turn
- Replace
- Pressure Spring
- Bolt
- 15 Nm + 90° turn
- Replace
- Balance Shaft Chain Sprocket
- Installed position: the side with lettering on it faces the transmission
- Chain Tensioner
- With glide track
- Bolt
- 10 Nm + 45° turn
- Replace