Overview - Balance Shaft
WARNING: This page is about a different variant/trim than selected.
- Balance Shaft
- Removing and installing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING
- Bolt
- 60 Nm
- For loosening and tightening, use the Locating PinsT40116 as a counterholder
- Balance Shaft Transmission Side
- Can only be placed on the balance shaft in one position
- Gear Carrier
- Bolt
- 13 Nm
- Balance Shaft Belt Pulley Side
- Can only be placed on the balance shaft in one position
- Bolt
- 60 Nm
- For loosening and tightening, use the Locating PinsT40116 as a counterholder