Engine Oil Cooler, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
- Tightening specifications. Refer to OIL PAN UPPER AND LOWER SECTIONS, OIL PUMP AND OIL COOLER OVERVIEW .
NOTE:
Replace any bolts that were tightened with an additional turn.
Replace the seal.
Secure all hose connections with hose clamps of the same type as those equipped by the factory.
-- Install the After-Run Coolant Pump -V51-. Refer to After-Run Coolant Pump -V51-, REMOVING AND INSTALLING .
-- Check the oil level. Refer to Maintenance, Diagnosis .
-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .