Engine Speed Sensor -G28-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Front/Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- On a vehicle with air suspension, activate vehicle lift mode, refer to Self-Leveling Suspension .

-- Remove the noise insulation -1- and -2-, refer to Exterior Equipment .

CAUTION:

Risk of distorting airbag spiral spring.

Separate universal joint from steering gear only when front wheels are in straight ahead position.
Secure steering wheel with adhesive tape to prevent position of steering wheel and steering gear from changing.

-- Remove the 2 bolts and then remove the steering gear heat shield -A-.

Fig 2: Identifying Steering Gear Heat Shield -A-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -B- for the universal joint, refer to Steering .

-- Remove universal joint from steering gear.

-- Remove the bolts -2- to be able to lower the rear subframe.

Fig 3: Identifying Bolts -4- And Engine Carrier Bolts -3-

Courtesy of AUDI OF AMERICA, LLC

WARNING:

The subframe could cause an accident if it is not secured.

-- Disconnect the connector -3-.

Fig 4: Identifying RPM Sensor, Cover And Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the cover -2-.

-- Remove the bolt -1- and the Engine Speed Sensor -G28-.