Camshaft Position Sensor -G40- / -G163-, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Camshaft Position Sensor -G40- Connector Location

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front engine cover, refer to ENGINE COVERS, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

-- Remove the bolt -arrow- and the Camshaft Position Sensor -G40- (cylinder bank 1).

-- Disconnect the connector -1-.

Fig 2: Camshaft Position Sensor 2 -G163- Connector Location

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- and the Camshaft Position Sensor 2 -G163- (cylinder bank 2).