Left Suction Jet Pump, Removing And Installing, Vehicles With 6.0L (V12) Engine: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2011 Audi Q7, and 2010 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Follow all safety precautions, refer to WORKING ON FUEL SYSTEM .

Follow the guidelines for clean working conditions, refer to CLEAN WORKING CONDITIONS .

To remove suction jet pump, fuel tank should be completely empty. Procedure to empty the fuel tank FUEL TANK, DRAINING .

-- Remove the left fuel delivery unit, refer to Fuel Pump - G23-, REMOVING AND INSTALLING, 6.0L (V12) ENGINE .

-- Reach though the opening on the right side of the fuel tank, press the releases and disconnect the delivery line -3-.

Fig 1: Fuel Delivery Lines Location

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -items 1 and 2-.

-- Reach into the fuel tank opening, press the locking tab -arrow 1- and remove the Fuel Level Sensor 2 -G169- -item 3- from the guide -4- -arrow 2-.

Fig 2: Identifying Removal Of Fuel Level Sensor 2 Out Of Guide -4- -Arrow 2- By Pressing Release Tab -Arrow 1-

Courtesy of AUDI OF AMERICA, LLC

-- Carefully remove the Fuel Level Sensor 2 -G169- through the fuel tank opening.

-- Reach through the opening in the fuel tank and pull the delivery line out through the opening on the left side of the fuel tank.

Fig 3: Removing Suction Jet Pump

Courtesy of AUDI OF AMERICA, LLC

-- Press the tab -arrow 1- and pull the suction jet pump out of the guide -arrow 2-.

NOTE:

The suction jet pump is illustrated without the fuel tank.

-- Remove suction jet pump carefully through the opening in the fuel tank.