LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (3.0L - Fuel Supply System - Engine Code(S): CATA & CNRB) >> 20 Fuel Supply >> Fuel Pump >> Fuel Pump Control Module -J538-, REMOVING AND INSTALLING >> Removing

Fuel Pump Control Module -J538-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2011 Audi Q7, and 2010 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The Fuel Pump Control Module -J538- is located at the front of the fuel tank below the exhaust system and driveshaft.

-- Turn off the ignition and remove the key.

WARNING:

Danger of getting burned.

  • Allow exhaust system to cool.

-- Remove the bolts/nuts -1 and 3-.

Fig 1: Identifying Fuel Pump (FP) Control Module, Bolts -1 & 3-, And Electrical Connector -2-
GWWA20-10164Courtesy of AUDI OF AMERICA, LLC

-- Disengage the Fuel Pump Control Module -J538- at the bracket -arrows-.

-- Disconnect the connector -2-.

scientia non olet · About LEMON Manuals