Driver Head Curtain Airbag Igniter -N251- AND Front Passenger Head Curtain Airbag Igniter -N252- OVERVIEW

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC, ELECTRICAL AND MECHANICAL RESTRAINT SYSTEM COMPONENTS, SAFETY PRECAUTIONS AND TESTING PROCEDURES .
Note the additional safety precautions when working on the side curtain airbag. Refer to HEAD CURTAIN AIRBAG ADDITIONAL SAFETY PRECAUTIONS .

Fig 1: Head Curtain Airbag With Driver/Passenger Head Curtain Airbag Igniter N251 And N252

Courtesy of AUDI OF AMERICA, LLC

Head Curtain Airbag
- Removing and Installing. Refer to Driver Head Curtain Airbag Igniter -N251- AND Front Passenger Head Curtain Airbag Igniter -N252-, REMOVING AND INSTALLING .
Connector
- For side curtain airbag.
- Disconnecting and connecting. Refer to Driver Head Curtain Airbag Igniter -N251- AND Front Passenger Head Curtain Airbag Igniter -N252-, REMOVING AND INSTALLING .
Bolt
- 5 Nm
- Self-locking
- Replacing
- Threaded holes for screws must always be cleaned (for example, with thread cutter).
Cap Nut
- 9 Nm
- On ground bolt.
Catch Strap
- In the front on the head curtain airbag.
- Must not cross with the wiring harness.