Outer Three-Point Seat Belt (2ND Row), Removing And Installing: Removing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn on the ignition.

-- Disconnect the ground cable from the battery with the ignition on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

Vehicles with Fixed Second Row

-- Remove corresponding second row seat.

Seat beach (two-thirds bench). Refer to SECOND ROW, 3 PASSENGER OVERVIEW .
Individual seat. Refer to SECOND ROW, 2 PASSENGER OVERVIEW .

Vehicles with Longitudinally Adjustable Second Row

-- Move second row seat forward on side to be removed.

Procedure for All Vehicles

-- Remove wheel housing liner -2- by removing screw -1- for belt webbing -3- from body. Refer to WHEEL HOUSING LINER OVERVIEW .

Fig 1: Identifying Belt Anchor/Seat Belt Screw -1- On Body

Courtesy of AUDI OF AMERICA, LLC

-- Remove the C-pillar trim. Refer to C-PILLAR TRIM OVERVIEW .

Vehicles with Air Duct in C-Pillar

Fig 2: Air Duct -A-

Courtesy of AUDI OF AMERICA, LLC

-- Remove screw -arrow- at belt guide.

-- Remove air duct -A-.

Vehicles with Pyrotechnic Belt Tensioners

WARNING:

Before handling belt tensioner units (for example, disconnecting electrical connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Unlock connector lock with a small screwdriver -2-.

Fig 3: Connector -1- From Belt Tensioner -3

Courtesy of AUDI OF AMERICA, LLC

-- Remove connector -1- from belt tensioner -3-.

Procedure for All Vehicles

-- Remove the belt relay from the seat belt height adjuster.

-- Remove belt roller/belt tensioner screw.

-- Remove belt roller/belt tensioner.