LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Passenger Protection, Airbags And Seat Belts) >> 69 Passenger Protection, Airbags, Seat Belts >> Seat Belts >> Belt Latch Anchorage Point, Removing And Installing >> Installing

Belt Latch Anchorage Point, Removing And Installing: Installing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Observe the following when doing so:

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC, ELECTRICAL AND MECHANICAL RESTRAINT SYSTEM COMPONENTS, SAFETY PRECAUTIONS AND TESTING PROCEDURES .

-- Vehicles with seat belt fasten sensor: make sure the wire is connected at position -3-.

scientia non olet · About LEMON Manuals