Belt Anchor, Removing And Installing: Installing
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Observe the following when doing so:
CAUTION:
- The spring -2- will get bent if it is removed incorrectly. Replace the three-point seat belt if the spring gets bent.
- Move the spring -2- just far enough until it is possible to unlock the tab on the spring.
-- Guide the belt end fitting through the seat belt guide on the seat.
-- Connect the belt anchor -3- to the bolt -1- -arrow A- and pull it up -arrow B-, until the spring catches -2- audibly lock on the bolt heat.
CAUTION:
Tug on seat belt to ensure that seat belt is securely locked to seat.