Passenger Occupant Detection System Deactivation After A Collision

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Each time an airbag or passenger belt tensioner deploys, a basic setting must be performed on the seat occupied recognition control module using the Vehicle Diagnostic Tester.
If the seat rails and/or seat pan is replaced after an accident due to deformations resulting from a crash, the passive occupant detection system must be replaced using the "passive occupant detection system service kit". Then a basic setting must be performed on the seat occupied recognition control module using the Vehicle Diagnostic Tester.