Child Seat Anchorage, Checking Function
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
To check function, you must install entire belt system, including side trim.
Switching Hold Function On
- Pull belt webbing out completely up to stop.
Correct Function
- Belt must retract with a chattering sound.
- If retracting process is stopped, belt cannot be pulled out anymore.
Deactivating
- Belt retraction to about 100 mm remaining.
- Hold function must switch off with a remainder of 100 mm, at the latest. Belt functions normally again.