Three Way Catalytic Converter (TWC), CHECKING

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

General Description

A catalytic converter is a vehicle emissions control device that converts toxic pollutants in exhaust gas to less toxic pollutants by catalyzing a redox reaction (oxidation or reduction). Catalytic converters are used in internal combustion engines.

General recommendations

Oxygen sensors OK.

No leaks or damage to exhaust system.

Prior to repair work, perform a preliminary check to verify the condition. Refer to .

Test Requirements

Fuses OK.
Battery voltage OK.
Switch OFF All electrical and electronic accessories.
Vehicles with Auto. Transmission, ensure Selector Lever position is in "P".
Vehicles with Manual Transmission, ensure Shifter Lever position is in "N" with Parking Brake applied.
Coolant Temperature: ≥ 80° C.
Observe all safety precautions: .
View clean working conditions: .
For Hybrid vehicles refer to: .

Test Procedure

Step	Procedure	Result / Action to Take
1	Activate Monitors: Perform the function test in the appropriate Diagnostic Mode 06. Refer to . End diagnosis and switch the ignition off. If the specified values are exceeded:	Check the exhaust system for leaks. If necessary, repair the leak(s) in the exhaust system. GO TO: Step 2
2	O2 Sensor Monitoring: Erase the DTC memory. Refer to . Perform a road test to verify repair. If the DTC does not return:	Generate readiness code. Refer to . If no leaks are found in the exhaust system: Replace the catalytic converter with front exhaust pipe. Refer to appropriate repair information. GO TO: Step 3
3	Final procedure Perform a road test to verify repair.	After the repair work, the following work steps must be performed in the following sequence: Check the DTC memory. Refer to . If necessary, erase the DTC memory. Refer to . If the DTC memory was erased, generate readiness code. Refer to . Return vehicle to Customer.