Ignition Coils: Removing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect electrical connectors at ignition coils by placing T10118 on release button -arrow- and carefully removing connector.

Fig 1: Disconnect Electrical Harness Connectors From Ignition Coils

Courtesy of AUDI OF AMERICA, LLC

-- Place T10095 A on ignition coils -arrow-, as shown in illustration, and pull out ignition coils one after another.

Fig 2: Attaching Puller For Ignition Coil T10095 A On Ignition Coils And Pulling Out Ignition Coils In Succession

Courtesy of AUDI OF AMERICA, LLC