Oil Pan, Oil Strainer And MECHATRONIC, Assembly Overview: Notes
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Screw
- 12 Nm
- tighten diagonally
- Securing oil pan to transmission
- ATF Drain Plug
- 12 Nm
- Always replace the bolt.
- ATF inspection and filler plug
- 80 Nm
- Always replace the bolt.
- Oil Pan
- Cover cap
- inserted in oil pan opening
- Magnet
- ensure full surface contact
- clean before installation
- Oil pan seal
- Always replace
- ATF Strainer
- Screw
- 8 Nm
- Note different lengths
- Following removal and installation instructions MECHATRONIC, REMOVING AND INSTALLING
- Mechatronic
- Seal