MECHATRONIC, Removing And Installing: Installing

Fig 1: Identifying Oil Seal For ATF Strainer From Transmission, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

Tightening specifications. Refer to OIL PAN, OIL STRAINER AND MECHATRONIC, ASSEMBLY OVERVIEW .

-- Make sure the seal -B- is installed correctly and is secure.

• If Mechatronic is replaced, then is it necessary to reaplce the seal -B- as well.

-- Set Mechatronic unit in place without using force, and at the same time insert stud on the selector lever -arrow- into the groove on the selector slide -A- ; if necessary, move selector slide back or forth.

Fig 2: Inserting Transmission Selector Lever Stud Into Groove On Selector Slide

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -1- and -2- on the Mechatronic to 2 Nm.

Fig 3: Identifying Bolts Tightening Sequence -1 To 10-

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts to tightening specification in the following sequence: -1 to 10-.

-- Replace the connector housing -A-.

Fig 4: Identifying Connector Housing -A-, O-Rings -1 To 2- And Locking Lever -Arrow 2-

Courtesy of AUDI OF AMERICA, LLC

-- Lightly coat the o-rings -1- and seals -2- on the new connector housing -A- with ATF.

-- Press the connector housing -A- all the way into the transmission -arrow 1-. Rotate it slightly if necessary.

-- Install the locking lever into the transmission -arrow 2-. Make sure it engages.

-- Install the ATF strainer. Refer to OIL SCREEN, REMOVING AND INSTALLING .

-- Install the ATF pan. Refer to ATF PAN, REMOVING AND INSTALLING .

-- Fill the ATF and check the level after installing. Refer to ATF, DRAINING OR FILLING AFTER REPAIR .

-- Complete the steps required after connecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .