ATF Pan, Removing And Installing: Installing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications. Refer to OIL PAN, OIL STRAINER AND MECHATRONIC, ASSEMBLY OVERVIEW .

-- Clean all magnets in oil pan recesses.

NOTE:

Make sure that the magnets are in full contact with the oil pan.

Replace the seal.

Replace the drain plug.

-- Clean the sealing surface from all sealant residue.

The sealing surfaces must be dry and free of grease.

-- Install the oil pan with new seal.

-- Tighten the oil pan bolts in stages and in sequence -1 to 13-.

-- Install the new drain plug.

-- Fill the ATF and check the level after installing. Refer to ATF, DRAINING OR FILLING AFTER REPAIR .