Vibration Damper: Installing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications, refer to Figure.

Installation is in reverse order of removal, note the following:

NOTE:

Replace bolts which have been tightened to torque.

-- Only install the vibration damper with its original bolts.

The vibration damper can only be installed in one position - note the alignment bushing.

-- Install ribbed belt. Refer to RIBBED BELT .