Oil Pressure Regulation Valve -N428-, Removing And Installing: Installation

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specification. Refer to OIL PAN UPPER SECTION OVERVIEW .

NOTE:

Replace the o-ring.

-- Install the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- On a vehicle with air suspension, deactivate vehicle lift mode. Refer to VEHICLE LIFT MODE .