Safety Precautions
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
If Testing Equipment Must Be Used During A Road Test, Observethe Following.
WARNING:
Distraction and testing equipment that is not secured properly can cause accidents.
The passenger airbag could pose a risk if it deploys in a collision.
- Operating testing equipment while driving causes it to shift position.
- There is an increased risk of injury due to unsecured testing equipment.
- Always secure testing equipment on the rear seat using a strap and have a second person in the rear seat operate it.
Observe the Following to Avoid Personal Injury and Vehicle Damage.
WARNING:
There is a risk of injury and accident from accidentally engaging a gear when the engine is running.
- Before working with engine running, move the selector lever to "P" and set the parking brake.
Observe the Following to Prevent Personal Injury and/or Damage to the Electrical/Electronic Components.
- Connect and disconnect test equipment only when the ignition is off.
CAUTION:
Danger of causing damage to electrical and electronic components.
- Be sure to follow the procedure for connecting the battery and afterwards. Refer to BATTERY, DISCONNECTING AND CONNECTING .