Information On 6-Speed Automatic Transmission 09D

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Transmission Design and Function

Refer to SSP # 662 - Audi Q7 - Engine/Transfer Case 0AQ and SSP# 300 - 6-Speed Automatic Transmission 09D.

In addition, you can learn more about the automatic transmission with the practice CD Multimedia Training; Powertrain Parts 1 to 3.

OBD

Before beginning any service work on the automatic transmission, determine the cause of the damage using Guided Fault Finding Vehicle Diagnostic Tester.

Transmission Control Module -J217-

Component location: Transmission Control Module -J217- is under the right front seat. Refer to Transmission Control Module - J217-, REMOVING AND INSTALLING .

Shift Point Changes on Inclines and Declines

An additional gear change map automatically selects the gear changes for gradients dependent upon accelerator pedal position and driving speed.

The gear change map for extreme uphill stretches is matched to engine output
The gear change map for extreme downhill stretches is matched to the braking effect of the engine.
Direct gear selection by way of the Tiptronic function permits utilization of engine braking action with a specific gear engaged, for example, on a downhill gradient with a trailer.