LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Automatic Transmission 0AT - Mechanism & Housing) >> 37 Mechanism And Housing >> Shift Mechanism, Servicing, Assembly Overview >> Selector Mechanism, Performing Emergency Release

Selector Mechanism, Performing Emergency Release

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

It is not possible to move the selector lever out of "P" if the battery is disconnected or if it is discharged.

The shift lock solenoid -N110- will cancel out the lock when the emergency release is activated.

Vehicles with ashtray:

-- Remove front ashtray insert.

Fig 1: Prying Off Cover Cap In Ashtray Housing Using Screwdriver
GWWA37-10060Courtesy of AUDI OF AMERICA, LLC

-- Pry off the cap inside the ashtray housing -arrow-.

Vehicles without ashtray:

-- Remove storage compartment in front of selector mechanism Interior Equipment

All:

-- Push the emergency release lever -arrow-, for example, with a screwdriver, and at the same time move the selector lever out of "P".

Fig 2: Pressing On Manual Release Lever Using A Screwdriver And Simultaneously Shift Selector Lever Out Of Position
GWWA37-10061Courtesy of AUDI OF AMERICA, LLC
NOTE:

The screwdriver will be guided through the funnel -1- to the emergency release lever.

Fig 3: Emergency Release Lever And Guide
GWWA37-10529Courtesy of AUDI OF AMERICA, LLC