Selector Mechanism Shift Unit, Removing And Installing: Installing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications: SHIFT MECHANISM, SERVICING, ASSEMBLY OVERVIEW

-- Insert selector mechanism shift unit from above into opening.

Ensure seal is seated correctly on selector mechanism shift unit.

-- Insert selector lever cable -3- through hole in selector mechanism shift unit.

-- Tighten the bolts -arrows-.

Fig 1: Identifying Hooks -1 To 2- And Bolts -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Install the hooks -1- and -2-.

-- Carefully insert boot -arrow- on selector lever cable all around in selector mechanism shift unit.

Fig 2: Pushing Boot Forward And Out From Shift Unit

Courtesy of AUDI OF AMERICA, LLC

-- Install shift mechanism function unit SHIFT MECHANISM FUNCTION UNIT, REMOVING AND INSTALLING .