Selector Lever Transmission Range Position Display Unit -Y26-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Unclipping Mounting Frame For Selector Lever Boot From Center Console

Courtesy of AUDI OF AMERICA, LLC

-- Move the selector lever into "N".

-- Remove the frame for the selector lever boot -1- -arrows-.

-- Fold up the selector lever boot.

-- Release the spring -2- and remove the selector lever transmission range position display unit -Y26- -1- -arrow-.

Fig 2: Releasing Retaining Spring And Removing Selector Lever Transmission Range (TR) Position Display Y26 Upward

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector.