Transmission Park Selector Switch -F305-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove selector mechanism function unit SHIFT MECHANISM FUNCTION UNIT, REMOVING AND INSTALLING .

-- Remove shift gate SHIFT GATE, REMOVING AND INSTALLING

-- Pry out the retaining pin -A- in -direction of arrow- with a screwdriver.

Fig 1: Identifying Part Of Shift Gate -1-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the first micro-switch -B-.

-- Disengage electrical wiring from tab -arrow C- and remove micro-switch from shift mechanism.

-- Disconnect the connector -D- from the shift lock solenoid -N110-.

Fig 2: Identifying Microswitch Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -E- upward.

-- Push the tab -C- in direction of -arrow 1-.

-- Remove the second micro-switch -B- in direction of -arrow 2-.

-- Disengage electrical line at selector mechanism -arrow A-.