Transmission Park Selector Switch -F305-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Part Of Shift Gate -1-

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

NOTE:

Coat the bearings and the sliding surfaces with polycarbamide greaseG 052 142 A2.

-- Guide micro-switch on longer electrical line into opening under parking lock button in selector mechanism.

-- Install the shift gate -1- from underneath.

Shift gate selector lever in "S" (as illustrated).

-- Install the micro-switch -B- into the shift gate and secure it with the retaining pin -A-.

NOTE:

Micro-switch must lie flush on all sides.

-- Attach the electric wire to the tab -arrow C-.

NOTE:

Retaining screws -A- secure the micro-switch -B- inside the shift gate.

Ignition key removal lock does not function correctly if micro-switch is not inserted correctly or properly secured.

-- Secure the electric wire -arrows A- to the selector mechanism as illustrated.

Fig 2: Identifying Microswitch Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Install the micro-switch -B-.

NOTE:

Ignition key removal lock does not function correctly if micro-switch is not inserted correctly or properly secured.

-- Connect the connector -D- to the shift lock solenoid -N110-.

-- Install the connector -E- from the top.

-- Install shift gate SHIFT GATE, REMOVING AND INSTALLING

-- Install shift mechanism function unit SHIFT MECHANISM FUNCTION UNIT, REMOVING AND INSTALLING .