Shift Lock Solenoid -N110-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the frame with the multimedia system control head -E380- -1-. Refer to Interior Equipment .

Fig 1: Pressing Up Installation Frame -1- For Multimedia Control Head -Arrow-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

Fig 2: Connect Connector -1- To Selector Lever Sensor System Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Remove the noise insulation -2- from the shift housing.

-- Remove the front ashtray or front storage compartment. Refer to Interior Equipment .

-- Remove the bolts -arrows- and -1- from the center console bracket.

Fig 3: Identifying Screws -1 To 3- And Front Screws -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

Fig 4: Electrical Connector -1- And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the four bolts -arrows-.

Fig 5: Bolts -Arrows-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The center console bracket is not shown in the illustration.

-- Remove center console bracket by tilting selector mechanism function unit.

-- Press and hold the parking lock button -C-.

Fig 6: Identifying Selector Rod And Shift Selector Lever, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Place selector lever in position "S".

-- Disconnect the connector -1- from the shift lock solenoid -N110-.

Fig 7: Identifying Shift Lock Solenoid N110 Electrical Connector And Releasing Retainer And Pulling Out Shift Lock Solenoid N110 From Front

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When removing magnets, lift them forward slightly so that ball head -2- disengages from the operating lever -1-.

Fig 8: Placing Shift Lock Solenoid N110 Into Guide At An Angle From Above

Courtesy of AUDI OF AMERICA, LLC

Shown with selector mechanism removed to provide a better illustration.

-- Open the catches -arrow A- and remove the shift lock solenoid -N110- forward -arrow B-.

Fig 9: Identifying Shift Lock Solenoid N110 Electrical Connector And Releasing Retainer And Pulling Out Shift Lock Solenoid N110 From Front

Courtesy of AUDI OF AMERICA, LLC