LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Automatic Transmission 0AT - Mechanism & Housing) >> 37 Mechanism And Housing >> Shaft Seals, Replacing - Assembly Overview >> Input Shaft Seal, Replacing >> Removing

Input Shaft Seal, Replacing: Removing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove transfer case TRANSFER CASE, REMOVING AND INSTALLING .

NOTE:

For the next step, install sheet metal screw so that it jams between seal and metal ring.

Fig 1: Identifying Output Shaft Seal, Removal
GWWN34-1691Courtesy of AUDI OF AMERICA, LLC

Be careful not to install the screw too deep otherwise the bearing underneath will get damaged.

-- Install sheet metal screw in shaft seal -arrow-.

-- Remove seal with PullerT10055.

scientia non olet · About LEMON Manuals