Input Shaft Seal, Replacing: Installing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Lubricate outer circumference and space between sealing lips with ATF.

Installation position: the open side of the seal faces the transmission.

-- Carefully guide shaft seal over output shaft to transmission and lightly press in with hand.

-- Drive in shaft seal as far as stop with Thrust PieceT40134. Do not tilt shaft seal when doing so.

-- Install transfer case TRANSFER CASE, REMOVING AND INSTALLING .

-- Check the ATF level and add, if necessary. Refer to ATF LEVEL INSIDE TRANSMISSION .