LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Automatic Transmission 0AT - Mechanism & Housing) >> 37 Mechanism And Housing >> ATF Pipes, ATF Thermostat And ATF Cooler, 6-Cylinder 3.6L FSI, Assembly Overview >> Notes

ATF Pipes, ATF Thermostat And ATF Cooler, 6-Cylinder 3.6L FSI, Assembly Overview: Notes

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying ATF Lines, Remove/Install Components
GWWA37-10439Courtesy of AUDI OF AMERICA, LLC
  1. ATF thermostat
    • Opening temperature approximately 75°C
  2. ATF Pipe
  3. O-Ring
    • Always replace
  4. Union nut
    • 20 Nm
    • Insert the pipe all the way by hand before tightening
  5. ATF Cooler
  6. Clamp
  7. ATF Pipe
  8. Screw
    • 5 Nm
  9. Clamps
  10. Bracket
    • Installed together with starter
  11. Screw
    • 25 Nm
    • before tightening, insert ATF pipes by hand into transmission as far as stop
  12. O-Ring
    • Always replace
  13. Screw
    • 5 Nm
  14. Bracket
  15. Screw
    • 10 Nm
    • before tightening, insert ATF pipes by hand into thermostat as far as stop
  16. O-Ring
    • Always replace