ATF Cooler, Removing And Installing: Removing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the bolts and remove front -1- and rear -2- noise insulation.

Fig 1: Identifying Front/Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Wear protective eyewear.

-- Remove both union nuts -4- at top of ATF cooler.

Fig 2: Identifying ATF Lines, Remove/Install Components

Courtesy of AUDI OF AMERICA, LLC

-- Press off clips -2- and -3-.

Fig 3: Identifying Screws On Rear Side Of Radiator

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore bolt -1-, does not need to be removed to remove ATF cooler.

-- Seal ATF pipes and ATF cooler -4- with clean plugs.

-- Remove ATF cooler -4-.