Reducing Agent Metering System Control Module -J880-, REMOVING AND INSTALLING: Removal

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Danger of causing damage to other electronic components when disconnecting the battery.

Complete the steps for disconnecting the battery.
Pay attention the to waiting period for vehicles with urea injection.

Fig 1: Pry Cover -1- With 80 - 200 From Floor Covering

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the ground cable -4- from the battery terminal. Refer to GROUND CABLE WITH Battery Monitoring Control Module -J367- FROM MY 09, REMOVING AND INSTALLING .

-- Remove the right rear single seat in the second row of seats. Refer to Seat Frames .

Fig 2: Reducing Agent Metering System Control Module -3-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right rear entry lamp. Refer to DOOR WARNING LAMP AND REAR ENTRY LAMP, REMOVING AND INSTALLING .

-- Press the floor covering to the side and disconnect the connector -1-.

-- Remove the nuts -2 and 4- and remove the Reducing Agent Metering System Control Module -J880- -3-.