LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q7 3.0 TDI >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (3.0L - Exhaust System & Emission Controls - Engine Code: CATA) >> 26 Exhaust System, Emission Controls >> Exhaust Manifold >> Left Intermediate Pipe, Removing And Installing >> Removal

Left Intermediate Pipe, Removing And Installing: Removal

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the primary catalytic converter. Refer to PRIMARY CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Remove the rear coolant pipe. Refer to REAR COOLANT PIPE, REMOVING AND INSTALLING .

-- Remove the exhaust gas recirculation auxiliary cooler. Refer to EGR AUXILIARY COOLER, REMOVING AND INSTALLING .

-- Remove the bolts -3- and -4- and remove the exhaust gas recirculation pipes.

Fig 1: Exhaust Gas Recirculation Pipes And Bolts
GWWA26-10748Courtesy of AUDI OF AMERICA, LLC
NOTE:

Bolts -1- and -2- were already removed.

-- Remove the air guide hose by loosening the hose clamps -arrows-.

Fig 2: Identifying Charge Air Hose Clamps -Arrows- And Hose
GWWA10-10484Courtesy of AUDI OF AMERICA, LLC

-- Remove the screws and nuts -arrows- and remove the left intermediate pipe.

Fig 3: Identifying Nuts And Bolts -Arrows-
GWWA26-10034Courtesy of AUDI OF AMERICA, LLC