EGR Motor -V338-, REMOVING AND INSTALLING: Removal

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Engine Cover

Courtesy of AUDI OF AMERICA, LLC

-- Carefully pull the engine cover off the 4 bolts one after the other -arrows-.

-- Remove the Exhaust Gas Recirculation Cooler Switch-Over Valve -N345- -arrow- from the bracket.

Fig 2: Identifying EGR Cooler Switch-Over Valve -N345- -Arrow- And Bracket

Courtesy of AUDI OF AMERICA, LLC

Vehicles through 05/2010:

Fig 3: Locating The Clamp -Arrow- And Remove The Coolant Hose.

Courtesy of AUDI OF AMERICA, LLC

-- Briefly open the coolant reservoir cap to reduce the residual pressure in the coolant system.

-- Loosen the clamp -arrow- and remove the coolant hose.

-- Seal any open lines and connections with a clean plug from the Engine Bung Set VAS 6122.

All vehicles:

Fig 4: Identifying Bolts -Arrows- And EGR Motor

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

-- Remove the screws -arrows- and remove the EGR Motor -V338-.