Tightening Specifications
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to SELECTOR LEVER AND Multifunction Transmission Range Switch -F125- .
- Refer to Figure.
-- Install the selector lever -2- on the selector shaft.
-- Install the washer -3- and tighten the nut -4-.
NOTE:
Selector shaft lever must not be bend when pressing selector lever cable on, counterhold if necessary.
-- Carefully press selector lever cable -2- onto selector shaft lever. Be careful not to bend the selector lever.
Install in reverse order of removal. Note the following:
-- Install the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .