Valve Body, Removing And Installing: Removing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Automatic Transmission Hydraulic Pressure Sensor 1 G193 & Automatic Transmission Hydraulic Pressure Sensor 2 G194

Courtesy of AUDI OF AMERICA, LLC

-- Remove the oil pan. Refer to ATF PAN, REMOVING AND INSTALLING .

-- Remove the oil screen. Refer to OIL SCREEN, REMOVING AND INSTALLING .

-- Disconnect the connectors from Automatic Transmission Hydraulic Pressure Sensor 1 -G193- -1- and Automatic Transmission Hydraulic Pressure Sensor 2 -G194- -2- carefully.

-- Remove the bolt -arrow-.

Fig 2: Identifying Connector Bolt -Arrow-

Courtesy of AUDI OF AMERICA, LLC

-- Unlock and disconnect the connector.

Fig 3: Carefully Releasing Connector And Pulling Off

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- from the Transmission Fluid Temperature Sensor -G93-.

Fig 4: Identifying Transmission Fluid Temperature Sensor G93

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the bolts on the valve body -arrows- diagonally and then remove them.

Fig 5: Identifying Valve Body Bolts

Courtesy of AUDI OF AMERICA, LLC