Overview - Transmission Fluid Pan, Transmission Fluid Screen And Valve Body
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Oil Pan
- Removing and installing. Refer to ATF PAN, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Spacer Sleeve
- Quantity: 16
- Attached to the oil pan gasket.
- Gasket
- Replace
- Bolt
- 10 Nm
- ATF Strainer
- Removing and installing. Refer to OIL SCREEN, REMOVING AND INSTALLING .
- Gasket
- Replace
- Bolt
- Note different lengths.
- Tightening specification and sequence. Refer to Fig 3.
- Valve Body
- Removing and installing. Refer to VALVE BODY, REMOVING AND INSTALLING .
- Bolt
- 10 Nm
- For Transmission Fluid Temperature Sensor -G93-.
- Bolt
- 10 Nm
- For the Transmission Output Speed Sensor -G195-.
- Transmission Output Speed Sensor -G195-
- O-Ring
- Replace
- Wiring Harness
- Threaded Pin
- 10 Nm
- Wiring Harness
- O-Ring
- Replace
- Automatic Transmission Hydraulic Pressure Sensor 2 -G194-
- 4.5 Nm
- Automatic Transmission Hydraulic Pressure Sensor 1 -G193-
- 4.5 Nm
- Magnet
- Quantity: 4
- Clean
- Make sure the entire surface contacts oil pan.
- Seal
- Replace
- ATF Drain Plug
- 21 Nm
- Seal
- Replace
- ATF Check Plug
- 70 Nm
-- Tighten the oil pan bolts -arrows- in stages and diagonally to 8 Nm.
NOTE:
Replace bolts that are tightened to the specification.
-- Tighten the bolts in 3 steps as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -Arrows- | Tighten the bolt hand-tight. |
| 2. | -Arrows- | 8 Nm diagonally |
| 3. | -Arrows- | 90° additional turn, diagonally |